On 7 September 1999 at 11:56 GMT a destructive earthquake (Mw = 6.0) occurred close to Athens (Greece). The rupture process is examined using data from the Cornet local permanent network, as well as teleseismic recordings. Data recorded by a temporary seismological network were analyzed to study the aftershock sequence. The mainshock was relocated at 38.105°N, 23.565°E, about 20 km northwest of Athens. Four foreshocks were also relocated close to the mainshock. The modeling of teleseismic P and SH waves provides a well-constrained focal mechanism of the mainshock (strike = 105°, dip = 55° and rake = -80°) at a depth of 8 km and a seismic moment M0 = 1.01025 dyn·cm. The obtained fault plane solution represents normal faulting indicating an almost north-south extension. More than 3500 aftershocks were located, 1813 of which present RMS < 0.1 s and ERH, ERZ < 1.0 km. Two main clusters were distinguished, while the depth distribution is concentrated between 2 and 11 km. Over 1000 fault plane solutions of aftershocks were constrained, the majority of which also correspond to N–S extension. No surface breaks were observed but the fault plane solution of the mainshock is in agreement with the tectonics of the area and with the focal mechanisms obtained by aftershocks. The hypocenter of the mainshock is located on the deep western edge of the fault plane. The relocated epicenter coincides with the fringe that represents the highest deformation observed on the differential interferometric image. The calculated source duration is 5 sec, while the estimated dimensions of the fault are 15 km length and 10 km width. The source process is characterized by unilateral eastward rupture propagation, towards the city of Athens. An evident stop phase observed in the recordings of the Cornet local stations is interpreted as a barrier caused by the Aegaleo Mountain. 相似文献
We show that spurious large non-double-couple components can be obtained in inversions for the full deviatoric moment tensor for shallow crustal earthquakes due to inaccurate Earth models. The traditional “best double-couple” solution does not in general provide an optimal estimate of a double-couple mechanism, and is only reliable when the non-double-couple component of the full deviatoric solution is small. The inverse problem for the moment tensors of the 1998 Antarctic Plate and 2000 Wharton Basin strike-slip earthquakes is shown in each case to have two well-fitting minima in the misfit function of pure double-couple solutions. Such pairs of solutions are most likely to exist for earthquakes which are close either to vertical strike-slip or to dip-slip on a fault plane dipping at 45°. It is shown theoretically that these pairs of solutions arise from the combination of the pure double-couple constraint and the instability of two elements of the moment tensor. No significant non-double-couple component is found for the shallow thrusting 1996 Biak, Indonesia earthquake. 相似文献
Thermal waters hosted by Menderes metamorphic rocks emerge along fault lineaments in the Simav geothermal area. Thermal springs and drilled wells are located in the Eynal, Çitgöl and Na
a locations, which are part of the Simav geothermal field. Studies were carried out to obtain the main chemical and physical characteristics of thermal waters. These waters are used for heating of residences and greenhouses and for balneological purposes. Bottom temperatures of the drilled wells reach 163°C with total dissolved solids around 2225 mg/kg. Surface temperatures of thermal springs vary between 51°C and 90°C. All the thermal waters belong to Na–HCO3–SO4 facies. The cold groundwaters are Ca–Mg–HCO3 type. Dissolution of host rock and ion-exchange reactions in the reservoir of the geothermal system shift the Ca–Mg–HCO3 type cold groundwaters to the Na–HCO3–SO4 type thermal waters. Thermal waters are oversaturated at discharge temperatures for aragonite, calcite, quartz, chalcedony, magnesite and dolomite minerals giving rise to a carbonate-rich scale. Gypsum and anhydrite minerals are undersaturated with all of the thermal waters. Boiling during ascent of the thermal fluids produces steam and liquid waters resulting in an increase of the concentrations of the constituents in discharge waters. Steam fraction, y, of the thermal waters of which temperatures are above 100°C is between 0.075 and 0.119. Reservoir pH is much lower than pH measured in the liquid phase separated at atmospheric conditions, since the latter experienced heavy loss of acid gases, mainly CO2. Assessment of the various empirical chemical geothermometers and geochemical modelling suggest that reservoir temperatures vary between 175°C and 200°C. 相似文献
This paper presents results recently obtained for generating site-specific ground motions needed for design of critical facilities. The general approach followed in developing these ground motions using either deterministic or probabilistic criteria is specification of motions for rock outcrop or very firm soil conditions followed by adjustments for site-specific conditions. Central issues in this process include development of appropriate attenuation relations and their uncertainties, differences in expected motions between Western and Eastern North America, and incorporation of site-specific adjustments that maintain the same hazard level as the control motions, while incorporating uncertainties in local dynamic material properties. For tectonically active regions, such as the Western United States (WUS), sufficient strong motion data exist to constrain empirical attenuation relations for M up to about 7 and for distances greater than about 10–15 km. Motions for larger magnitudes and closer distances are largely driven by extrapolations of empirical relations and uncertainties need to be substantially increased for these cases.
For the Eastern United States (CEUS), due to the paucity of strong motion data for cratonic regions worldwide, estimation of strong ground motions for engineering design is based entirely on calibrated models. The models are usually calibrated and validated in the WUS where sufficient strong motion data are available and then recalibrated for applications to the CEUS. Recalibration generally entails revising parameters based on available CEUS ground motion data as well as indirect inferences through intensity observations. Known differences in model parameters such as crustal structure between WUS and CEUS are generally accommodated as well. These procedures are examined and discussed. 相似文献
We study the October 18, MW = 7.1, 1992 Atrato earthquake, and its foreshocks and aftershocks, which occurred in the Atrato valley, northwestern Colombia. The main shock was preceded by several foreshocksof which the MW = 6.6, October 17 earthquacke was the largest. Inparticular, we examine foreshocks and aftershocks performing joint-hypocenter relocations using high quality Pn and Sn wave readingsfrom permanent regional networks. We observed a few hours prior to the main shock a sudden increase of foreshocks. Maybe this could be used as a predictor since foreshocks have been known for other major events in the region. Our locations align for 90 km with a trend of 5° ±4° in agreement with the Harvard CMT solution showing the faultplane trending 9° to be the plane of rupture. In relation to theepicenter of the main shock, maximum intensities were located to thesouth, consistent with a rupture that traveled from north to south witha larger energy release in the south as suggested by an empirical Green'sfunction study (Li and Toksöz, 1993; Ammon et al., 1994). The boundarybetween the Panama and North Andes blocks has been placed close to thePanama-Colombia border as either a sharp boundary or a diffuse zone. TheAtrato earthquake, however, shows that the plate boundary between thePanama and North Andes microblocks is a diffuse deformation zone. Thiszone has a width of at least 2° stretching from 78°W to 76°W. Quantification of earthquake moment release (during the past30 years) in this zone shows a similar amount of moment release in thewestern and eastern parts of this zone. 相似文献